Aroma Diffuser Base Plates & Feet
Plan custom molded base plates, feet and underside covers around mounting points, support stability and cable or ventilation openings.
Start with the mounting stack
Provide the locations of the housing joints, fasteners, circuit board and cable connections. Identify which surfaces locate the base and the areas that need tool access during assembly. If a fastener or cable retainer is supplied separately, include its drawing or sample.
Define support and foot attachment
Mark the intended contact points and the surface on which the finished diffuser will sit. For separate pads, specify their shape, recess, attachment and thickness in the assembled position. Check rocking and cable clearance with the complete assembly on the intended surface.
Review the underside openings and clearances
Identify vents, drainage features and cable slots separately on the drawing. Mark openings that must remain clear after assembly and the areas where the bottom may meet condensate or cleaning liquid. Confirm any appliance-level airflow, electrical or stability requirements on the finished unit.
Frequently asked questions
Can the plastic base be quoted without the rubber pads?
Yes. Identify the plastic part and any separate pads in the part list. Share the pad drawing or sample so its recess and assembled height can be reviewed with the base.
What should we check if the trial assembly rocks?
Check the base against the agreed reference surface and confirm the pad thickness, mounting sequence and any parts that prevent the base from seating. Use a complete assembly to identify the cause before changing the mold.
Discuss your drawing with OPINOX.
Plan custom molded base plates, feet and underside covers around mounting points, support stability and cable or ventilation openings.