Aroma Diffuser Control Panel Bezels & Button Frames
Review molded control trims, switch frames and indicator-window holders for fit, finish and access to the user controls.
Tie the bezel openings to the actual controls
Supply the circuit board layout or the positions of the switches, indicator lights and ports. Identify which surfaces locate the trim in the housing and where clearance is needed for button movement or a cable plug. Include the mating housing and intended control parts when reviewing first samples.
Specify appearance around the visible perimeter
Mark the visible perimeter and any specified gap or height difference relative to the outer shell. Provide color or texture references for the trim and its mating shell. Use the visible-side drawing to discuss gate and ejector witness locations before tooling.
Define indicator and legend checks on the assembly
If a light window, molded legend or separate label is part of the design, show its position relative to the light source and controls. Agree the appearance checks in ambient light and with the indicator on. Confirm who supplies any insert, label or printed artwork.
Frequently asked questions
Can I keep the same electronics when redesigning the trim?
Provide the board and switch locations that must stay fixed, plus the existing housing interfaces. Review the new trim around those constraints and verify access with the original components.
Should the light window be part of the same molded piece?
Compare the options against the required light appearance, surface finish and assembly. If the light window is separate, include its interface and retention method in the tooling review.
Discuss your drawing with OPINOX.
Review molded control trims, switch frames and indicator-window holders for fit, finish and access to the user controls.